Wagan 2005-1 Manual de usuario descargar pdf (Pagina 10)

Slim Line

™

Power Inverters by Wagan Tech

www.wagan.com

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

INSTALLATION

Safe installation requires that a Battery Protection fuse is installed within one foot of

the positive (+) battery Terminal [red]. Use ANL marine fuses or equal because they

do not spark when they blow. Use an appropriate fuse holder for the fuse. ANL

fuse holders can be mounted so they do not move in a vehicle or vessel.

CONNECTING THE INVERTER

Loose DC (battery) connections will result in a severe voltage drop that can

cause damage to connectors, conductors, and insulation and can cause

sparking. Reverse polarity connection can permanently damage to the inverter.

Damage caused by reverse polarity will void the warranty.

WARNING:

Venting batteries produce explosive, corrosive gases. There is danger of

explosion. DO NOT connect or disconnect BATTERY cables directly after battery

discharge or recharge. Make sure that the battery bank area is well vented

before attaching or removing cables.

NOTES: All recommended cable gauges and fuse sizes are located at the rear

of this manual in the Cable Gauge Table. The table describes Cable Gauges for

lengths greater than supplied cables.

“Round Trip” refers to actual cable distance in feet from the POS (+) battery

terminal through the inverter and back to the NEG (−) battery terminal.

Crimp-on ring terminals are required on all cable ends. The cable ends need to

be stripped of insulation for ½ inch before crimping on ring terminals. Select

a crimp terminal size to ﬁt the cable gauge and inverter and battery terminal

connectors. After crimping, make sure that the cable connectors are secure on

the cables so there are no loose connections.

CAUTION: Making an initial connection between the positive cable end and

the inverter’s positive terminal may cause a spark. This is normal and is a result

of capacitors in the inverter starting to charge. Because of the possibility of

sparking, it is extremely important that both the inverter and the battery bank be

positioned away from any source of ﬂammable fumes or gases. Failure to heed

this warning can result in ﬁre or explosion. Do not make the positive terminal

connection immediately after the batteries have been charging. Allow time for

the battery gasses to vent to outside air.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sin comentarios

Wagan 2005-1 Manual de usuario Pagina 10